The use of the word "New" means a new item to the page and not the condition of the item.(unless otherwise specified)! All items as is /where is. Shipping costs (including packing material) not included.

This is a non-commercial site.  No COD's without a 20% non-refundable deposit.

Looking for pipe organ and electronic organ parts and organs?   Check out New and Used Electronic and Pipe Organ parts and materials.

CAPACITORS

NO MORE AVAILABLE, but have a12uFD, 4900vdc Version for $35 each, 4 or more $30 each. 32uFD, 4500VDC, oil cap, 3-3/4" x 4-5/8" x 9-5/8", <7.5 lbs, $60 each , 4 or more, $50 each (This is the same one that sales for $120+ through a source-of-supply listed in the handbook"), More on order.

CAPS - VACUUM VARIABLES - none

INDUCTORS - make offer!!

• Inductor, roller, M15-40V, 15uH, 40 amp, 8 turn, 10" dia, 7" lgt., $200 ($480 new) believe to be unused

MISC - make offer!!

• 3ph rectifier stack, Westinghouse built, about 4" w, 12" h. The three phase diodes can be rewired for single phase, $25

• Vacuum relays, various kinds, RB1D $25 ea. (4 for $90), others, some new (unused), $30

• 8877 sockets (Ceramic - with grid connectors) $15

• B&W dipole center section, $10, have two

TEST EQUIPMENT

• HP scope, $75

• Leader LCR bridge (Expensive unit!!) $200 (no cal)

TRANSFORMERS/Power Supplies

• Misc open frame and small circuit board type, like 5v 3a, etc, +/-15V, +/-12V

• 12.6VCT 80amp, NEW $35

• 8877, 3CX1000 filament transformers, have around 3 at 15 ea. 

6el 60' 20 mtr, 15mtr, 7 el 10mtr.Also had 3-el 40mtr, 5-el 20, 15, 10 on 50' boom	lst 6el "KLM" style 20 mtr beam, converted from a 5-el KLM in 1976.  Later KLM marketed this antenna with only one or two minor dim. changes from the ones I supplied.
1980 amp on right had 3CX3000A7 but never completed.  Chassis ended up missing while I lived in Dallas, (along with a 4 20' sections of red, white, and blue painted tower, and a Harris 3-1000Z pretuned amp)  Anyone there seen them??	Early boy scout days (1955). I am on the left and Jerry Spears,  W7DOR is on the right

THE FOLLOWING ARE HAVE BEEN SOLD THRU THE INTERNET!!

• DSP units: 59+ $150

• 8877 chimney

• Henry plate (used with pair of 3CX1000A7, around 2800v, 1A

• 100uFD, 2500VDC, oil cap

• Rotary coil, approx 1/8" dia. gold plated rotary coil, motor driven.

• 2-el quad arms, approx 13' each section NEW

• Bencher key

• 3CX3000A7 or similar socket

• 3" spiders, 2 pcs.

• 3800v (secondary is 16-17ga, 18 ohm, primary is 220v or 208v) calculated about 3-4 amps

• Henry tuned inductor, measured inductance @120Hz, 3.95Hy, w/tuning caps (3), (used with above) core size 4" x 5-1/2" x 6-3/8"

• MFJ HF/VHF SWR Analyzer with RF resistance meter

• Yaesu FT-2700RH 25W, 2mtr/440MHz duplex with tone squelch, mounting bracket, scanning mic

• ICOM IC-2KL

• Power supply filter choke used in 3CX3000A7 commercial amp, don't know value yet, but checking.

• 12uFD, 5200VDC, similar to above. 6 pieces, $35 each.

• 3CX15,000B7

• 3CX1,200A7, two tubes

• 2300pf Vac. Cap

• 120uFD, 3000VDC, oil cap, GE, 13"h x 13.5"w x 5.25"d

• Vibroplex Brass Racer

• Bird thruline section with two slugs, 500w and 2500w

• 3CX3000A7, two tubes with ECONCO test data

• Socket and chimney for 4CX10,000, includes fil., screen, and coupling caps

• Curtis little bugger keyer

• 3CX3000A7 rf generator rf deck and control circuitry and separate rf deck with 3-500Z driver (driver in driven by a solid state amp on same deck).

• MFJ tunable dsp

• ICOM IC-738

• 7.5VCT, 50amp

• 9uH, 20 amp

• AEA radio link

• 8877 socket and chimneys, 2 pcs

• Ameritron AL-1200, xfmr still in factory sealed box

• 3CX800A7, three tubes $200 each, all three for

• Amp Supply LK-550, three 3-500Z's, QSK, Separate Peter Dahl 1.75A CCS power xfmr.

• Rohn tower 55, 80'+, with cables, torque arms, etc.

• Dummy load 1200w continuous

• ICOM IC-775DSP

• Inductor, roller, Johnson, as used in Henry amps

• HV xfmr for 8877, three hv taps, fil and control winding.

• 32uFD, 4500VDC, oil caps,

• 3CX15,000B7 tubes

• 3CX3000F1 tubes

• Euro desk 24-4 audio mixer

• MFJ 1.5kw Versatuner

• Drake MN-2000 antenna tuner

• Rohn tower 25, 30'

• Kenwood TS820 w/cw filter, remote vfo, dc supply, heil element in mic

• Cushcraft R7 vertical

• ARD 230, autotune HF linear, pair of 3CX800A7, remote control head and also computer controlled. Peter Dahl transformer

• Yaseu FT1000D

• Cushcraft 40 meter beam

• ICOM IC-738, estate sale

• Isotron 80 meter

• Isotron 40 meter $50

• Drake L4-B linear amplifier

• 3CX1000A7, two tubes pr w/sockets and chimneys

• Kenwood 250 Hz cw filter

• Kenwood TS930 with ant. tuner, narrow cw filter, am filter

• Kenwood Twins, "D" nice conditions

• 5uFD, 7.5kV, oil cap

• Yaesu FT2100B, two 572B in final, around 1200 watt linear amp

• Cushcraft R7 vertical